Free Shipping on Orders of $99.99 or more!

Garage Sale

Edelbrock 2716 Performer EPS Vortec Intake Manifold for Small Block Chevy


Sku: EDE 2716

Availability: Out of stock

$241.70

Quick Overview

Edelbrock 2716 Performer EPS Vortec Intake Manifold for Small Block Chevy

Details

[[ProductTitle]]

Edelbrock Part # 2716 Performer EPS Vortec intake manifold is now available for small-block Chevys with Vortec or Edelbrock E-Tec cylinder heads, the Performer EPS dual-plane manifold is optimized to deliver superior performance with Edelbrock square-bore Performer Series or Thunder Series AVS carburetors. The runner design is モtunedヤ for peak torque around 3500 rpm on a 350-inch engine and itメs ideal for power from off-idle to 5500 rpm. Dyno tests showed gains averaging 5+ ft-lbs. of torque from 3000 to 4500 rpm for more performance where you need it most. Match with a dependable Edelbrock square-bore carburetor for maximum performance gains. Will not fit under stock Corvette hood.

Specs

Warranty 12 Months
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Manifold ht: A-3.87", B-5.28
  • Carb pad height: 4.57"
  • Carb recommendations: Edelbrock AVS2 or Performer Series 500-650 cfm
  • Port exit dimensions: 2.05" tall with slanted side walls.
  • Recommended intake gasket: Edelbrock # 7235
  • Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant # 1076, DO NOT USE END SEALS GASKETS.
  • Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
  • NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.
  • DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
  • Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
  • Will not fit under stock Corvette hood.
  • Even though manifolds are compatible with EGR systems, this does not mean they are legal for use on emissions controlled vehicles. Check local laws for legality.
  • Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Center Maximum Height 3.200 in
CNC Ported No
Color Satin
Front Maximum Height 2.500 in
Material Aluminum
Rear Maximum Height 3.900 in
Single Or Dual Plane Type Dual Plane

Additional Information

SKU EDE 2716
Manufacturer Part Number 2716
Brand Edelbrock
Color N/A
UPC 085347027163
Size Large

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Year Make Model Trim Engine