Eibach 0950.500.0900 Front Spring Dirt Modified 5x9.5 ID 900 lbs/in
Eibach uses the worlds finest quality, chrome silicon steel wire to produce coil springs with maximum travel and minimum weight. Eibach Springs are metric sized and, therefore, not limited to the SAE sized wire used in the production of many of the springs currently on the market. Eibach Springs are cold formed on CNC machinery, insuring precise tolerances on spring rates and free height, as well as longer life expectancy. Eibach Springs are heat tempered, shot peened, pre-set, and again tempered for maximum stress resistance. During a final process, they are phosphate treated and red powder coated with a very durable epoxy coating for a great looking finish tha resists chipping and provides maximum protection from corrosion. All springs are imprinted with an Eibach logo and part number for assurance of quality. Eibach Springs are guaranteed to remain within 3% rate and height for the life of the spring.
Ultra-Lightweight for Reduced Unsprung Mass
Maximum Deflection in Combination with Smallest Block Heights
Exceptional Block Resistance and Durability
Precision Tolerances - The Tightest in the Industry
Precision Planparallel and Square End Configurations Under Unloaded and Loaded Conditions to ± Degree
Lowest Side Loads with Load Center Ideally Located Relative to Spring Axis
Highest Linearity and Guaranteed Rate Consistency Within 2% Of Advertised Rate
Total Reviews (0)
Write the First Review!