13" x 5" 50LBS EIBACH PLATINUM REAR SPRING
EIB PR1300.500.0250
Ultra Light-Weight Using High Tensile Steel
More Travel / Deflection than Standard Racing Coil Springs
Block Resistant - No Loss in Spring Height!
Flat-Ground End Configuration with Parallel Tolerance to +/-1 Degree
The Eibach ER Platinum Springs will Maintain Their Dimensions and Rates to Incredibly Tight Tolerances, Lap after Lap, Race after Race
Eibach uses the worlds finest quality, chrome silicon steel wire to produce coil springs with maximum travel and minimum weight. Eibach Springs are metric sized and, therefore, not limited to the SAE sized wire used in the production of many of the springs currently on the market. Eibach Springs are cold formed on CNC machinery, insuring precise tolerances on spring rates and free height, as well as longer life expectancy. Eibach Springs are heat tempered, shot peened, pre-set, and again tempered for maximum stress resistance. During a final process, they are phosphate treated and red powder coated with a very durable epoxy coating for a great looking finish tha resists chipping and provides maximum protection from corrosion. All springs are imprinted with an Eibach logo and part number for assurance of quality. Eibach Springs are guaranteed to remain within 3% rate and height for the life of the spring.
- Designed specifically for Dirt Modifieds
- Utilizes Eibach's Proprietary Ultra-High Tensile Alloy
- More travel, reducing Shear Loads and Stores More Energy increasing Grip
- Ultra-Lightweight
- Each spring is wound to Exact Tolerances and Dyno Tested
- Made in the USA
| Type |
Length |
OD |
Rate |
| Platinum Rear |
13 |
5 |
250 |
Total Reviews (0)
Write the First Review!